邯郸电动门厂

1固定门体:

1 fixed door body:

将门体放入轨道，尾部的底撑用专用固定卡及地脚膨胀螺钉(M12×80)固定。

The door body is placed on the track, and the bottom support of the tail is fixed with a special fixed card and a foot expansion screw (M12 x 80).

2限位开关:

2 limit switch:

按照设定门体的开、关位置埋设限位装置。

Set the limit device according to the opening and closing position of the set door.

3固定控制盒:

3 fixed control box:

控制盒可以装在机头箱内，也可移至离主机10米之内的室内。

The control box can be installed in the head box, and can also be moved to the room within 10 meters from the host.

4连接线路:

4 connection lines:

严格按接线图依次接好相对应的连线(严禁在通电状态下接线)，接线要牢固，端子与端子之间不能短路，并捡查线路是否正确。

In strict accordance with the wiring diagram, the corresponding connection should be connected in sequence (no connection is strictly prohibited in the electrified state). The connection must be firm, and there is no short circuit between terminals and terminals, and check whether the lines are correct.